Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

Arlo Go 2 LTE Security Camera - Restart Device

2026-10-22 21:01:01.568

Arlo Go 2 LTE Security Camera - Restart Device

Here's how to restart your Arlo Go 2 security camera if it crashes and resets, freezes or runs slow.
  • A soft reset (turning the device off then back on) is similar to restarting a desktop computer and is one of the first steps in troubleshooting a device.
  • In most cases, a soft reset won't affect data on the device, unless the battery is very low.
  1. Open the Arlo app or navigate and sign in to the Arlo web portal at https://arlo.netgear.com/ via a browser.
    The Arlo web portal doesn't support Internet Explorer®. For more info visit Arlo system requirements.
    If necessary, install the Arlo app.
    If the device is unresponsive, remove then re-insert the battery.
  2. From the Devices tab, tap or click the
    Settings icon
     Settings icon (to the right of the desired camera name).
  3. Tap or click
    RESTART
    .
    May require scrolling to the bottom.
  4. To confirm, tap or click 'OK' or 'Restart'.
    Allow several seconds for the process to complete.